PAS Pedal Assist Sensor, stealth design with 12 Magnets for E-Bikes – Precise, Smooth, and Easy to Install
This pedal assist sensor (PAS) system comes as a one part system. The magnet wheel attaches to the exposed part of the bottom bracket where the crank arm connects. It intersects with the ‘teeth’ of the end of the BB shell. The type of BB needed is shown in the first product picture. As it is a 1 piece design PAS it is far more reliable as you no longer need to be concerned by the distance between the magnet wheel and the sensor.
Featuring 12 magnets on the PAS, this sensor delivers precise pedal detection and reliable performance across a wide range of e-bike systems.
KEY FEATURES
-
12-magnet wheel for accurate pedal rotation detection
-
Provides smooth, natural motor assist response
-
Compatible with most e-bike controllers and systems
-
Easy installation when used with a standard screw in bottom bracket. See product photo for compatible BB type.
-
Waterproof 3 Pin Higo connector for secure, reliable connections
SPECIFICATIONS
-
Cable Length (to connector end): 180mm
-
Weight: 40g
-
Magnet Disc Dimensions: 79mm diameter, 4mm thick
-
Connector Type: 3 Pin Higo Waterproof
IMPORTANT NOTES
- Bottom Bracket NOT included. Shown in picture to show which type of BB this sensor interfaces with.
-
Ensure sensor alignment is correct: the gap between the sensor and magnets should not exceed 3mm for optimal performance.
-
Designed to mount on the left-hand (non-drive side) of the cranks.
- These are compatible with all the Bafang controllers we sell on this site. If you plan to use it with a different controller make sure to check the pinout in the product photos, to ensure it is the same specification that you require.